1.6L/2.4L MODELS (Except Diesel AND Turbo)

WARNING: This page is about a different variant/trim than selected.

Fig 1: Clutch Slave Cylinder at Transaxle- 1.6L Models

Courtesy of CHRYSLER LLC

1 - SLAVE CYLINDER

2 - BOLT

The clutch slave cylinder (1) consists of a hydraulic piston and cylinder, seal and return spring. See Fig 1. It is fastened to the transaxle bellhousing. The slave cylinder is connected to the clutch master cylinder hydraulic pipe, which is retained to the cylinder by a pair of retainer clips, and has a bleed port to facilitate the removal of air from the system.

Fig 2: Clutch Slave Cylinder at Transaxle - Typical

Courtesy of CHRYSLER LLC

1 - SLAVE CYLINDER

2 - BRACKET

2.4L-equipped models utilize a separate mounting bracket (2).