LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> PT Cruiser Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (1.8L Engine (Service Information)) >> Cylinder Head >> BUCKET, Tappet >> Standard Procedure >> Measuring Valve Lash >> Clearance too Large

Clearance too Large

WARNING: This page is about a different car, the 2009 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: TAPPET IDENTIFICATION
GC0082431Courtesy of CHRYSLER LLC
  1. Remove camshafts. See Engine/Cylinder Head/CAMSHAFT, Engine - Removal .
  2. Clearance - specification = change.
  3. Increase tappet thickness by change figure.
  4. Install camshafts. See Engine/Cylinder Head/CAMSHAFT, Engine - Installation .
  5. Verify that valve lash is correct.
scientia non olet · About LEMON Manuals