LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> PT Cruiser Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Tires & Wheels (Service Information)) >> Wheels >> STUD, Wheel, Front >> Removal >> Removal

STUD, Wheel, Front: Removal: Removal

WARNING: This page is about a different car, the 2009 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Use the following procedure to remove one of five studs on one wheel hub.
  1. Access and remove front brake rotor. Refer to Brakes/Hydraulic/Mechanical/ROTOR, Brake - Removal .
    CAUTION: Do not hammer wheel mounting studs out of the hub. Damage to the wheel bearing will occur, leading to premature bearing failure.
    Fig 1: Removing Front Wheel Stud Using Remover Tool 8677
    GC0082303Courtesy of CHRYSLER LLC
  2. Install Remover 8677 (3) on the hub flange (1) and wheel stud (2).
  3. Tighten the Remover, pushing the wheel mounting stud out the rear of the hub flange. When the shoulder of the stud is past the flange, remove the Remover from the hub.
  4. Remove the stud from the hub flange.
scientia non olet · About LEMON Manuals