Possible Causes
WARNING: This page is about a different car, the 2009 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.
| Possible Causes |
|---|
| INTERMITTENT DTC |
| (B15) BRAKE SIGNAL 1 CIRCUIT SHORTED TO GROUND |
| (B16) BRAKE SIGNAL 2 CIRCUIT SHORTED TO VOLTAGE |
| (F202) FUSED IGNITION SWITCH OUTPUT (RUN-START) CIRCUIT OPEN OR HIGH RESISTANCE |
| (Z967) GROUND CIRCUIT OPEN OR HIGH RESISTANCE |
| (B15) BRAKE SIGNAL 1 CIRCUIT OPEN OR HIGH RESISTANCE |
| (B16) BRAKE SIGNAL 2 CIRCUIT OPEN OR HIGH RESISTANCE |
| STOP LAMP SWITCH |
| POWERTRAIN CONTROL MODULE (PCM) |
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. See DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure .