LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> PT Cruiser Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (DTCS P1502 To P209) >> P1513-Starter Request Switch Stuck >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2009 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.
  1. DTC IS ACTIVE 
    1. Ignition on, engine not running.
      NOTE: This DTC can set by holding the ignition switch in the start position after the engine starts.
    2. With the scan tool, select View DTCs.

      Is the status Active for this DTC?

      Yes 

      • Go to step  2

      No 

  2. (F963) START ENABLE CIRCUIT SHORTED TO VOLTAGE 
    1. Turn the ignition off.
    2. Disconnect the Powertrain Control Module (PCM) connector.
    3. Turn the ignition on.
    4. Measure the voltage of the (F963) Start Enable circuit in the Powertrain Control Module (PCM) harness connector.

      Is there any voltage present?

      Yes 

      No 

      • Go to step  3
  3. POWERTRAIN CONTROL MODULE (PCM) 
    1. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors between the ignition switch and the Powertrain Control Module (PCM).
    2. Look for any chafed, pierced, pinched, or partially broken wires.
    3. Look for broken, bent, pushed out or corroded terminals.
    4. Monitor the scan tool data relative to this circuit and wiggle test the wiring and connectors.
    5. Look for the data to change or for the DTC to reset during the wiggle test.
    6. Refer to any Technical Service Bulletins that may apply.

      Were any problems found?

      Yes 

      No 

scientia non olet · About LEMON Manuals