Stored Lost Communication DTCS: Notes
WARNING: This page is about a different car, the 2009 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.
For complete wiring diagrams, refer to SYSTEM WIRING DIAGRAMS .
- When Monitored:
With the ignition on.
Battery voltage between 10 and 16 volts.
IOD fuse installed.
Totally Integrated Power Module (TIPM) is configured correctly.
- Set Condition:
Bus messages not received for approximately 2 to 5 seconds.
| Possible Causes |
|---|
| CAN B BUS CIRCUITS OPEN OR SHORTED |
| CAN C BUS CIRCUITS OPEN OR SHORTED |
| DTCS RELATED TO BATTERY VOLTAGE, IGNITION, OR VIN MESSAGES |
| TIPM NOT CONFIGURED CORRECTLY |
| POWER OR GROUND FROM THE REPORTING MODULE |
| MODULE THAT SET THIS DTC |
| PREVIOUS SERVICE PERFORMED WITHIN THE LAST 100 KEY CYCLES (FUSE/RELAYS REMOVED, WIRING SERVICE, BATTERY DISCONNECT) |
| LOW BATTERY/JUMP START CONDITION |
| IOD FUSE WAS REMOVED DURING SHIPPING |
| CHECK FOR RELATED TSBS |