SWITCH, Oil Pressure: Removal: Removal
WARNING: This page is about a different car, the 2009 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the negative battery cable.
- Raise and support the vehicle. Refer to Vehicle Quick Reference/Hoisting - Standard Procedure .
- Remove the splash shield from the right side frame rail. Refer to Body/Exterior/SHIELD, Splash - Removal .
- Remove the accessory drive belt. Refer to Cooling/Accessory Drive/BELT, Serpentine - Removal .
- Remove the three bolts (2) and reposition the A/C compressor (1).
- Disconnect the oil pressure switch electrical connector.
- Remove the oil pressure switch using oil pressure socket C-4597 (1) or equivalent.