LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> PT Cruiser Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (2.0L Engine (Service Information)) >> Engine Block >> SEAL, Crankshaft Oil, Rear >> Installation >> Installation

SEAL, Crankshaft Oil, Rear: Installation: Installation

WARNING: This page is about a different car, the 2009 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Rear Main
GC0084063Courtesy of CHRYSLER LLC
CAUTION: If a burr or scratch is present on the crankshaft edge (chamfer), cleanup with 800 emery cloth to prevent seal damage during installation of new seal. If emery cloth is used, the crankshaft must  be cleaned off Mopar® brake parts cleaner.
NOTE: When installing seal, lubricate Seal Guide 9509 with clean engine oil.
  1. Place Seal Guide 9509 (3) on crankshaft.
  2. Position seal (2) over guide tool. Guide tool should remain on crankshaft during installation of seal. Ensure that the lip of the seal is facing towards the crankcase during installation.
  3. Drive the seal into the block using Seal Driver 9706 (1) and Driver Handle C-4171 (4) until Seal Driver 9706 bottoms out against the block.
    Fig 2: Identifying Washer, Flex Plate, & Flex Plate Bolts
    GC0098637Courtesy of CHRYSLER LLC
  4. Install the flexplate (1) and transmission. See Engine/Engine Block/FLEXPLATE - Installation .
scientia non olet · About LEMON Manuals