LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> PT Cruiser Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (2.0L Engine (Service Information)) >> Cylinder Head >> SPRING(S), Valve >> Installation >> Cylinder Head On

Cylinder Head On

WARNING: This page is about a different car, the 2009 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Care must be taken not to damage the tappet bore or engine damage may result.
Fig 1: Removing/Installing Valve Seal/Valve Spring Seat Assembly, Valve Spring, Retainer, & Keepers
GC0102859Courtesy of CHRYSLER LLC
  1. Install valve seal/valve spring seat (3) assembly. Push the assembly down with appropriate size socket to seat it onto the valve guide.
  2. Install valve spring (2) and retainer (4) with keepers (1).
    Fig 2: Identifying Installer & Remover Tools
    GC0102860Courtesy of CHRYSLER LLC
  3. Place the valve keepers in the retainer. Using metric valve keeper tool such as Snap-on® GA317 (or equivalent) installer (2) and remover (1) as a handle, install valve keepers with a downward push.
  4. Remove air hose and install spark plugs.
  5. Install valve tappets.
  6. Install camshafts. See Engine/Cylinder Head/CAMSHAFT, Engine - Installation .
  7. Install cylinder head cover. See Engine/Cylinder Head/COVER(S), Cylinder Head - Installation .
scientia non olet · About LEMON Manuals