Replacement Drive Motor
WARNING: This page is about a different car, the 2009 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.
- Upon first powering up the sunroof, continuously press the close button on the power sunroof switch. The sunroof will begin moving in the tilt up direction.
- The glass panel will move to the hard stop (just past the full tilt position) and then reverse to the soft stop (the full tilt position).
- Once the sunroof has reversed immediately (within 5 seconds of stopping travel), release the switch and continuously press the close button again.
- The sunroof glass will continue to move to the fully closed position. Once fully closed the close button can be released.