Erasing Transmitter Codes

WARNING: This page is about a different car, the 2009 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Individual channels cannot be erased. Erasing the transmitter codes will erase ALL programmed codes.

To erase programming from the three buttons (individual buttons cannot be erased but can be "reprogrammed"), follow the step noted:

Press and hold the two outer HomeLink® buttons until the indicator light begins to flash after 20 seconds. Release both buttons. Do not hold for longer that 30 seconds. HomeLink® is now in the train (or learning) mode and can be programmed at any time beginning with "Programming". See Electrical/Universal Transmitter/TRANSMITTER, Universal - Standard Procedure .