LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> PT Cruiser Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Lamps & Lighting System - Interior (Service Information)) >> LAMP, Dome >> Removal >> Unit

LAMP, Dome: Removal: Unit

WARNING: This page is about a different car, the 2009 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Cargo Lamp & Dome Lamp
GC0102604Courtesy of CHRYSLER LLC
  1. On lower line vehicles, there will be two overhead lamps located at (1 and 2). (1) is the Cargo Lamp, and (2) is the Dome Lamp.
    Fig 2: Removing/Installing Dome Lamp Unit
    GC0102606Courtesy of CHRYSLER LLC
  2. From the front of the dome lamp, insert a trim stick between the dome lamp unit bezel (3) and the headliner and gently pry down to release the clip (5) holding the unit to the roof panel , and the two clips (1) holding it to the headliner.
  3. Pull the dome lamp forward to release the two tabs (3) from the headliner.
  4. Disconnect the wire connector (2).
  5. Remove the dome lamp unit from vehicle.