Lamp - Without Flashlight Feature
WARNING: This page is about a different car, the 2009 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
There are two types of cargo lamps available in this vehicle; one with and one without a removable flashlight feature.
- Disconnect and isolate the battery negative cable.
- Insert the tip of a small flat bladed screwdriver into the notch (5) between the lens (2) and the housing (1) on one side of the cargo lamp unit.
- Gently pry the end of the lens downward until it unsnaps from the housing.
- Swing the lens downward until it is perpendicular to the housing.
- Pull the lens hinge/retainer end (3) of the housing downward slightly from the headliner, then slide the exposed end of the housing away from the mounting hole far enough to disengage the fixed retainer (4) on the notched end from the headliner.
- Pull the lamp away from the headliner mounting hole far enough to access and disconnect the wire harness connector from the connector receptacle on the back of the lamp housing.
- Remove the lamp from the vehicle.