SENSOR, Camshaft Position: Removal: Rear

WARNING: This page is about a different car, the 2009 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Camshaft Position Sensor Heat Shield - Installed

Courtesy of CHRYSLER LLC

Disconnect negative battery cable.
Disconnect electrical connector at sensor.
Remove nut retaining heat shield.

Fig 2: Identifying Camshaft Position Sensor Heat Shield - Removed
Courtesy of CHRYSLER LLC
Pull heat shield out to uncover sensor.
Remove mounting bolt.

Fig 3: Removing/Installing Camshaft Position Sensor
Courtesy of CHRYSLER LLC
Remove sensor.