LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> PT Cruiser Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Ignition Control (Service Information)) >> SENSOR, Camshaft Position >> Installation >> Rear

SENSOR, Camshaft Position: Installation: Rear

WARNING: This page is about a different car, the 2009 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Camshaft Position Sensor
GC0082375Courtesy of CHRYSLER LLC
  1. Lubricate sensor O-ring.
  2. Install sensor utilizing twisting motion. Make sure sensor is fully seated. Do not drive sensor into the bore with screw. This can cause sensor to be incorrectly seated causing engine to fail.
  3. Install mounting bolt and tighten to 9 N.m (79.5 in. lbs.).
    Fig 2: Identifying Camshaft Position Sensor Heat Shield - Removed
    GC0082377Courtesy of CHRYSLER LLC
  4. Carefully attach electrical connector to camshaft position sensor. Feel for positive lock (click). Installation at angle may damage the sensor pins.
  5. Install heat shield onto mounting stud.
  6. Install heat shield retaining nut and tighten.
    Fig 3: Identifying Camshaft Position Sensor Heat Shield - Installed
    GC0082376Courtesy of CHRYSLER LLC
  7. Connect negative battery cable.
scientia non olet · About LEMON Manuals