LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> PT Cruiser Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Continuously Variable Transmission (CVT) (Service Information)) >> Fluid >> Standard Procedure >> Transmission Fill

Transmission Fill

WARNING: This page is about a different car, the 2009 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.

To avoid overfilling transmission after a fluid change or overhaul, perform the following procedure:

  1. Verify that the vehicle is parked on a level surface.
  2. Remove the dipstick tube cap.
  3. Add following initial quantity of MOPAR® CVTF+4, Automatic Transmission Fluid, to the transmission:
    1. If only fluid and filter were changed, add 7.0 L (14.8 pts.)  of transmission fluid to transmission.
    2. If the transmission was completely overhauled or the torque converter was replaced or drained, add 8.1 L (17.1 pts.)  of transmission fluid to transmission.
  4. Check the transmission fluid. See Transmission and Transfer Case/Automatic - CVT/FLUID - Standard Procedure  and adjust as required.
scientia non olet · About LEMON Manuals