Erasing Diagnostic Trouble Codes
WARNING: This page is about a different car, the 2009 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.
The scan tool must be used to erase a DTC.
The following procedures may be used to diagnose the charging system if:
- the check gauges lamp or battery lamp is illuminated with the engine running
- the voltmeter (if equipped) does not register properly
- an undercharged or overcharged battery condition occurs.
Remember that an undercharged battery is often caused by:
- Accessories being left on with the engine not running.
- A faulty or improperly adjusted switch that allows a lamp to stay on. Refer to IGNITION-OFF DRAW TEST .
- loose generator belt.