Diagnostic Test

WARNING: This page is about a different car, the 2009 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.

VERIFY DTC IS ACTIVE
NOTE: Verify the IOD fuse is installed and battery voltage is between 10 and 16 volts before proceeding.
1. Turn the ignition on.
2. With the scan tool, read and record ABS DTCs.
3. With the scan tool, read and record Environmental Data to help identify the conditions in which the DTC was set.
4. With the scan tool, erase ABS DTCs.
5. Cycle the ignition switch.
6. With the scan tool, read ABS DTCs.
  Does this DTC reset?
  
  Yes
  - Go to step 2
  No
  - Perform the Stored Lost Communication test procedure. Refer to Non-DTC Diagnostics/Communication - Diagnosis and Testing .
CHECK FOR ANY OF THE FOLLOWING ACTIVE DTCs
1. With the scan tool, read all active DTCs from all CAN C Bus modules.
  NOTE: Check for CAN C hardware electrical, VIN Missing/Mismatch, battery or ignition related DTCs.
  
  Does the scan tool display any active DTCs related to the conditions listed above?
  
  Yes
  - Perform the appropriate diagnostic procedure.
  No
  - Go to step 3
VERIFY THAT THE TIPM IS ACTIVE ON THE BUS
1. With the scan tool, select ECU View.
2. Verify that the TIPM is active on the bus.
  Is the TIPM active on the bus?
  
  Yes
  - Go to step 4
  No
  - For No Response diagnostic procedures. Refer to Non-DTC Diagnostics/Communication - Diagnosis and Testing .
CHECK FOR ADDITIONAL COMMUNICATION RELATED DTCs
1. With the scan tool, select Network View and select Advanced.
  Is there more than one module with active DTCs."Logged Against" the TIPM?
  
  Yes
  - Replace/update the TIPM in accordance with the service information.
  - Perform BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .
  No
  - Replace the Anti-Lock Brake Module in accordance with the service information.
  - Perform ABS VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Antilock Brake (ABS) - Standard Procedure .