Primary Thermostat - Gas Engine
WARNING: This page is about a different car, the 2009 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - COOLANT HOSE |
| 2 - INLET HOUSING |
| 3 - BOLT |
- Partially drain THE cooling system. See Cooling - Standard Procedure .
- Remove THE air filter housing. See Cooling - Standard Procedure
- Disconnect the coolant hose (1) from the inlet housing (2).
- Remove inlet housing bolts (3).
- Remove the thermostat assembly, and clean the sealing surfaces.