Gas Engine
WARNING: This page is about a different car, the 2009 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - WATER PUMP |
| 2 - MOUNTING BOLT |
| 3 - WATER INLET TUBE NUTS |
| 4 - INLET WATER TUBE |
- Remove the accessory drive belt. See Cooling/Accessory Drive/BELT, Serpentine - Removal .
- Raise vehicle. Refer to Vehicle Quick Reference/Hoisting - Standard Procedure .
- Remove accessory drive belt splash shield.
- Drain cooling system. See Cooling - Standard Procedure .
- Remove screws attaching water pump pulley (1). Remove pulley (1).
- Remove water pump mounting bolts (2).
- Remove water pump (3).