Gas Engine
WARNING: This page is about a different car, the 2009 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - WATER PUMP |
| 2 - MOUNTING BOLT |
| 3 - WATER INLET TUBE NUTS |
| 4 - INLET WATER TUBE |
- Position the water pump assembly (1) and gasket onto the cylinder block.
- Position the water inlet tube (4) and gasket onto the water pump (1).
- Install the mounting bolts (2). Tighten the bolts to 24 N.m (18 ft. lbs.).
- Install the drive belt splash shield.
- Lower the vehicle.
- Install the accessory drive belt. See Cooling/Accessory Drive/BELT, Serpentine - Installation .
- Evacuate air and refill cooling system. See Cooling/Engine/PUMP, Water - Standard Procedure
- Check cooling system for leaks. See Cooling - Diagnosis and Testing