UNIT, Front Lamp: Removal: Unit: Domestic
WARNING: This page is about a different car, the 2009 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.
- Open hood.
- Disconnect and isolate the battery negative cable.
- Loosen the fascia on the side you're taking the front lamp unit out on. Refer to Frame and Bumpers/Bumpers/FASCIA, Front - Removal . The fasteners along the radiator closure panel, the splash shield to fascia screws, and the bolt holding the fascia to the fender at the wheel well opening.
- Remove the three screws (3) to the front lamp unit (4) to body.
- Pull the front lamp unit (4) straight back to unsnap the ball and socket pivots from the retainer (1).
- Maneuver the front lamp unit out of its mounting pocket, enough to expose the individual lamp (1) electrical connectors (2 and 3).
- Disconnect the two electrical connectors (2 and 3).