Front Position Lamp - Export

WARNING: This page is about a different car, the 2009 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Splash Shield Fasteners

Courtesy of CHRYSLER LLC

Disconnect and isolate the battery negative cable.
Hoist vehicle.
Working in the appropriate wheel well, loosen up the front of the splash shield, but don't fully remove it. Refer to Body/Exterior/SHIELD, Splash - Removal .

Fig 2: Front Lamp Unit
Courtesy of CHRYSLER LLC
Looking up through the front wheel well, locate the front position lamp (3).
Grasp the front position lamp (3) twist 1/4 turn counterclockwise, and pull straight out of front lamp unit.
Pull bulb straight from its socket.