UNIT, Front Lamp: Installation: Bulbs

WARNING: This page is about a different car, the 2009 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Headlamp Bulb

Courtesy of CHRYSLER LLC

NOTE: The headlamp bulb can be accessed from under the hood without the removal of the inner fender well. It will be necessary to remove the inner fender well to service the park/turn signal bulb that is located toward the outboard side of the head lamp unit.

Reaching up through wheel well, install the headlamp or park/turn signal bulb (1) in the front lamp unit, locking it into place by twisting a 1/4 turn clockwise.
NOTE: EXPORT ONLY - If installing/replacing the headlamp bulb on export vehicles push the bulb straight in unit and then install the spring clip. Install the rubber cover over the rear of the lamp housing, over the headlamp bulb.
Connect the bulb electrical connector (2 or 3).

Fig 2: Front Splash Shield Fasteners
Courtesy of CHRYSLER LLC
Install the front of the splash shield (6) removed to gain access to the front lamp unit bulbs. Refer to Body/Exterior/SHIELD, Splash - Installation .
Lower vehicle from hoist.
Connect the battery negative cable.