LAMP, Tail: Removal: Unit: Domestic

WARNING: This page is about a different car, the 2009 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Push Pins Retaining Tail Lamp Unit

Courtesy of CHRYSLER LLC

Disconnect and isolate the battery negative cable.
Using a trim stick or equivalent, pry out the two push pins (2) retaining the tail lamp unit (1).

Fig 2: Tail Lamp Unit
Courtesy of CHRYSLER LLC
Pull straight back on the tail lamp unit (5) to release it from the quarter panel (4).
Disconnect the three electrical connectors (1, 2, and 3) to the tail lamp unit (5).
Remove the tail lamp unit (5) from the vehicle.
Remove the bulb sockets from the lamp unit by rotating the sockets counterclockwise, and then pull straight out of the unit.