LAMP, Tail: Removal: Bulbs

WARNING: This page is about a different car, the 2009 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Tail Lamp Unit Bulbs

Courtesy of CHRYSLER LLC

There are a total of four possible bulbs in the tail lamp unit:

Back-Up Lamp (4)
Park/Brake Lamp (1)
Rear Fog Lamp (5) - Export Only
Turn Signal (3)

Fig 2: Tail Lamp Unit Bulbs

Courtesy of CHRYSLER LLC

Remove the tail lamp unit. See Electrical/Lamps/Lighting - Exterior/LAMP, Tail - Removal .
NOTE: It is not necessary to completely remove the tail lamp unit. Once loosened from quarter panel, there should be enough room to service any of the bulbs.
Disconnect the electrical connector.
Remove bulb socket from tail lamp unit by twisting a quarter turn counterclockwise.
Pull socket straight out of tail lamp unit.
Pull bulb from socket.