LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> PT Cruiser Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Heating & Air Conditioning (Service Information)) >> Cabin Heater >> Unit, Heater >> Installation >> Installation

Unit, Heater: Installation: Installation

WARNING: This page is about a different car, the 2009 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: PTC Heater Unit
GC0082742Courtesy of CHRYSLER LLC
NOTE: LHD model shown. RHD model similar.
  1. Carefully install the positive temperature coefficient (PTC) heater unit (2) into the left side of the HVAC air distribution housing (3). Make sure to position the two locator tabs on the end of the heater unit into the molded locator indentations on the right side of the air distribution housing.
  2. Install the two screws (1) that secure the PTC heater unit to the air distribution housing. Tighten the screws to 1.2 N.m (10 in. lbs.).
    Fig 2: Identifying PTC Heater Connector
    GC0084700Courtesy of CHRYSLER LLC
    NOTE: PTC heater shown removed from distribution housing for clarity.
  3. Connect the wire harness connector (1) to the PTC heater unit (3) while pushing upward on the connector lock (2). Make sure the wire harness connector and lock are fully engaged.
  4. Install the instrument panel. Refer to Body/Instrument Panel/PANEL, Instrument - Installation .
  5. Reconnect the negative battery cable.
scientia non olet · About LEMON Manuals