Gas Engine

WARNING: This page is about a different car, the 2009 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Supply Hose At Power Steering Pump

Courtesy of CHRYSLER LLC

Slide hose clamps (2) onto both ends of the power steering fluid supply hose (1) far enough to clear the fittings on the reservoir and pump once the hose is installed.
Place the pump end of the supply hose (1) onto the pump (3) supply fitting. Expand the hose clamp (2) and slide it over the hose and pump supply fitting. Secure the clamp once it is past the bead formed into the fluid supply fitting.

Fig 2: Removing/Installing Supply Hose Clamp At Power Steering Fluid Reservoir
Courtesy of CHRYSLER LLC
Expand the hose clamp (4) at the fluid reservoir (5) and slide it over the hose and fitting. Secure the clamp once it is past the bead formed into the fluid reservoir fitting.
Perform the Power Steering Pump Bleed Procedure. See Steering - Standard Procedure .
Check for leaks at all hose connections.