Gas Turbo Engine

WARNING: This page is about a different car, the 2009 Dodge Caliber. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Before proceeding, see Steering - Warning .

Siphon as much fluid as possible from the power steering fluid reservoir.
Raise and support the vehicle. Refer to Vehicle Quick Reference/Hoisting - Standard Procedure .

Fig 1: Identifying Fastener At Power Steering Hose Routing Clamps - Turbo Gas Engine
Courtesy of CHRYSLER LLC
Remove the fastener (1) securing the power steering hose routing clamps to the left side of the crossmember.

Fig 2: Removing/Installing Pressure Hose At Steering Gear - Turbo Gas Engine
Courtesy of CHRYSLER LLC
Remove the pressure hose (1) at the steering gear (2).
lower the vehicle.
Remove the engine appearance cover.
Remove the air cleaner housing.
- For 1.8L engine, refer to REMOVAL .
- For 2.0L engine (Gas), refer to REMOVAL .
- For 2.4L engine, refer to REMOVAL .
Fig 3: Removing/Installing Pressure Hose At Pump Pressure Port - Turbo Gas Engine
Courtesy of CHRYSLER LLC
Remove the pressure Hose (3) at the pump (2) pressure port.

Fig 4: Removing/Installing Pressure Hose Routing Clamp Bolt At Left Side Of Engine - Turbo Gas Engine
Courtesy of CHRYSLER LLC
Remove the pressure hose routing clamp bolt (2) at the left side of the engine.
Remove the power steering pressure hose from the engine compartment. Remember how the hose routes through the engine compartment for ease of installation.