Diagnostic Test
- ACTIVE DTC NOTE: Diagnose all CAN B and C communication DTCs before continuing.NOTE: For vehicle communication problems, use the scan tool to refer to the Network Review Screen. The screen depicts a high level view of the vehicle network. Fault and problem areas appear in red. Selecting any of the network components allows access to the source of the problem.
- Ignition on, engine not running.
- With a scan tool, select View DTCs.
Is the status Active for this DTC?
Yes
- Go to step 2
No
- Perform the INTERMITTENT CONDITION diagnostic procedure. See DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure .
- CAN B BUS COMMUNICATION DTCS ALSO ACTIVE
- With a scan tool select View DTCs in the TIPM.
Are any CAN B Bus DTCs active?
Yes
- Refer to DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Diagnosis and Testing and perform the appropriate diagnostic procedure.
No
- Replace and program the Powertrain Control Module (PCM) in accordance with the Service Information.
- Perform the PCM Verification Test. See DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure .
- With a scan tool select View DTCs in the TIPM.