Diagnostic Test

ECT SENSOR VOLTAGE BELOW 0.078 OF A VOLT
1. Ignition on, engine not running.
2. With a scan tool, read the ECT voltage.
  Is the voltage below 0.078 of a volt?
  
  Yes
  - Go to step 2
  No
  - Refer to the INTERMITTENT CONDITION Diagnostic Procedure.
  - Perform the POWERTRAIN VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure
ECT SENSOR
1. Turn the ignition off.
2. Disconnect the ECT harness connector.
3. Ignition on, engine not running.
4. With a scan tool, read ECT voltage.
  Is the voltage above 1.0 volt?
  
  Yes
  - Replace the ECT Sensor.
  - Perform the POWERTRAIN VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure
  No
  - Go to step 3
(K2) ECT SIGNAL CIRCUIT SHORTED TO THE (K900) SENSOR GROUND CIRCUIT

Fig 1: Checking ECT Signal Circuit
Courtesy of CHRYSLER LLC
1. Turn the ignition off.
2. Disconnect the PCM harness connectors.
3. Measure the resistance between the (K900) Sensor ground circuit and the (K2) ECT Signal circuit in the ECT Sensor harness connector.
  Is the resistance below 5.0 ohms?
  
  Yes
  - Repair the short to between the (K900) Sensor ground circuit and the (K2) ECT Signal circuit.
  - Perform the POWERTRAIN VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure
  No
  - Go to step 4
(K2) ECT SIGNAL CIRCUIT SHORTED GROUND

Fig 2: Checking ECT Signal Circuit
Courtesy of CHRYSLER LLC
1. Measure the resistance between ground and the (K2) ECT Signal circuit in the ECT Sensor harness connector.
  Is the resistance below 100 ohms?
  
  Yes
  - Repair the short to ground in the (K2) ECT Signal circuit.
  - Perform the POWERTRAIN VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure
  No
  - Go to step 5
PCM
NOTE: Before continuing, check the PCM harness connector terminals for corrosion, damage, or terminal push out. Repair as necessary.
1. Using the schematics as a guide, inspect the wire harness and connectors. Pay particular attention to all Power and Ground circuits.
  Were there any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the POWERTRAIN VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure
  No
  - Replace and program the Powertrain Control Module per Service Information.
  - Perform the POWERTRAIN VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure