Visor - Installation

INSTALLATION

WARNING: All vehicles equipped with airbags must have a colored coded, five bullet point, airbag warning label applied to the sun visor. If replacement of a sun visor is required, make sure to install a new warning label.

NOTE: Convertible Model shown in illustration. Hardtop model similar.





1. Position the sun visor (1) to the windshield surround frame or roof panel (2) (depending on application) and connect the wire harness connector (3), if equipped.
2. Install the two screws (4) that secure the sun visor to the windshield surround frame or roof panel (depending on application).
3. Position the sun visor retainer (5) to the windshield surround frame or roof panel (depending on application).
4. Install the screw that secures the sun visor retainer to the windshield surround frame or roof panel (depending on application).
5. Engage the sun visor to the sun visor retainer.