B2324

B2324-HEADLAMP WASHER MOTOR CONTROL CIRCUIT HIGH

For a complete wiring diagram, refer to the Wiring Information Electrical Diagrams.

- When Monitored:
With the ignition on.

- Set Condition:
When the Totally Integrated Power Module (TIPM) detects a short/high condition.





HEADLAMP WASHER RELAY
1. Turn the ignition off.
2. Replace the Rear Wiper relay with a known good relay.
3. With the scan tool, clear all TIPM DTCs.
4. Turn the Rear Wipers ON then OFF.
5. With the scan tool, read the TIPM DTCs.

Does the scan tool read: B2324-REAR WIPER MOTOR CONTROL CIRCUIT HIGH?

Yes

- Replace the Integrated Power Module.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Test complete.
- Perform the BODY VERIFICATION TEST. Body Verification Test.