B1BC7

B1BC7-DEPLOYMENT DATA RECORD FULL

For a complete wiring diagram refer to the Wiring Information Electrical Diagrams.

- When Monitored:
With the ignition on. The module's on board diagnostics continuously performs internal circuit tests.

- Set Condition:
This DTC will set if the module identifies an out of range internal circuit.





REPLACE THE OCCUPANT RESTRAINT CONTROLLER

WARNING: Turn the ignition off disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

WARNING: If the airbag control module is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental airbag deployment and serious or fatal injury.

View repair.

Repair

- Replace the Occupant Restraint Controller.
- Perform the ORC SYSTEM VERIFICATION TEST. Occupant Restraint Controller (ORC) Verification Test.