B1B97

B1B97-PASSENGER SEAT TRACK POSITION SENSOR CONFIGURATION MISMATCH





For a complete wiring diagram refer to the Wiring Information Electrical Diagrams.

- When Monitored:
With the ignition on the OCM monitors the Seat Track Position Sensors circuits.

- Set Condition:
If the module detects current on the Seat Track Position Sensors circuits and the module is not configured for STPS.





1. CHECK FOR ACTIVE INTERNAL FAULTS, IGNITION FAULTS, AND BATTERY FAULTS IN THE OCCUPANT CLASSIFICATION MODULE (OCM)

NOTE: Ensure the battery is fully charged.

1. Turn the ignition on, then off, and then on again.
2. With the scan tool, read Occupant Classification Module (OCM) DTCs.

Does the scan tool display any active DTCs relating to internal faults, ignition faults, or battery faults?

Yes

- Diagnose and repair the DTCs. Testing and Inspection.

No

- Go To 2

2. VERIFY THAT B1B97-PASSENGER SEAT TRACK POSITION SENSOR CONFIGURATION MISMATCH IS ACTIVE
1. With the scan tool, erase OCM DTCs.
2. Turn the ignition off, wait 10 seconds and then turn the ignition on.
3. Wait 2 minutes, and then with the scan tool, read OCM DTCs.

Does the scan tool display active: B1B97-PASSENGER SEAT TRACK POSITION SENSOR CONFIGURATION MISMATCH?

Yes

- Go To 3

No

- Perform the OCM VERIFICATION TEST. Occupant Classification Module (OCM) System Verification Test.

3. VERIFY WIRING
1. Turn the ignition off.
2. Inspect the passenger seat wiring for Seat Position Sensors.

Are Seat Position Sensor(s) present?

Yes

- Replace the OCM.
- Perform the OCM VERIFICATION TEST. Occupant Classification Module (OCM) System Verification Test. WARNING: If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.

No

- Perform the OCM VERIFICATION TEST. Occupant Classification Module (OCM) System Verification Test.