B1A24

B1A24-KEY NOT PROGRAMMED

For a complete wiring diagram, refer to the Wiring Information Electrical Diagrams.

- When Monitored:
With the ignition on.





PROGRAM ALL OF THE IGNITION KEYS
1. Turn the ignition on.
2. With the scan tool, attempt to program the key(s) into the WCM.

Was the programming of the key(s) successful?

Yes

- Perform the WCM VERIFICATION TEST. . Wireless Control Module (WCM) Verification Test

No

- Replace the ignition key and attempt to program it into the WCM. If the DTC resets, replace and program the Sentry Key Remote Entry Module (WCM). NOTE: If this vehicle is equipped with a Steering Column Lock Module, it must be replaced along with the WCM.

- Perform the WCM VERIFICATION TEST. . Wireless Control Module (WCM) Verification Test