LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Engine & Automatic Transmission Cooling System >> Engine >> Thermostat >> Installation >> 3.0L Diesel

3.0L Diesel

  1. Clean all sealing surfaces.
  2. Position and install thermostat housing Tighten bolts to 9 N.m (80 in. lbs.).
    NOTE: Inspect condition of all clamps and hoses, replace as necessary.
  3. Connect coolant hoses,
  4. Install bracket for fuel line.
  5. Close coolant drain.
  6. Install engine cover.
  7. Connect negative battery cable.
  8. Fill coolant system to proper level. See Cooling - Standard Procedure .
  9. Start engine and inspect for leaks.
scientia non olet · About LEMON Manuals