LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Engine & Automatic Transmission Cooling System >> Engine >> PUMP, Water >> Removal >> 3.0L Diesel

3.0L Diesel

Fig 1: Water Pump - 3.0L Diesel
GC0079914Courtesy of CHRYSLER LLC
WARNING: Risk of injury to skin and eyes from scalding with hot coolant. Risk of poisoning from swallowing coolant. Do not open cooling system unless coolant temperature is below 90°C (194°F). Open cap slowly to release pressure. Store coolant in suitable and appropriately marked container. Wear protective gloves, clothes and eye wear.
  1. Disconnect the negative battery cable.
  2. Remove the engine cover.
  3. Drain the engine coolant. See Cooling - Standard Procedure .
  4. Disconnect and remove the upper radiator coolant hose.
  5. Remove the accessory drive belt. See Cooling/Accessory Drive/BELT, Serpentine - Removal .
  6. Remove the EGR valve. Refer to REMOVAL .
  7. Remove the water pump and clean the sealing surfaces.