Diagnostic Test

DETERMINING IF DIAGNOSTIC TROUBLE CODE (DTC) IS CURRENT
1. With the scan tool, erase the WIN DTCs.
2. Turn the ignition off.
3. Wait 10 seconds.
4. Turn the ignition on and wait 2 minutes.
5. With the scan tool, read the WIN DTCs.
  Does the scan tool display the DTC that was previously erased?
  
  Yes
  - Go to step 2
  No
  - Go to step 4
VERIFY THE PCM VIN
1. Turn the ignition on.
2. With the scan tool, select Engine system from the main menu.
3. Display and record the Vehicle Identification Number.
  NOTE: Ensure that a VIN has been programmed into the PCM. If a VIN is not displayed, attempt to program the PCM with the correct VIN before continuing.
  
  Does the VIN recorded from the PCM match the VIN of the vehicle?
  
  Yes
  - Go to step 3
  No
  - Update the VIN in the PCM in accordance with the Service Information.
  - Perform the WIN VERIFICATION TEST. See DTC-Based Diagnostics/NODE, Wireless Ignition (WIN) - Standard Procedure
REPLACE THE WIN AND CHECK DTC'S
1. Turn the ignition off.
2. Replace and program the Wireless Ignition Node in accordance with the Service Information.
3. Turn the ignition on.
4. With the scan tool, display and clear all PCM and WIN DTCs.
5. Perform 5 ignition key cycles leaving the ignition key on for 90 seconds per cycle.
6. With the scan tool, check for WIN DTCs.
  Does the scan tool display the same DTC?
  
  Yes
  - Replace and program the Powertrain Control Module in accordance with the Service Information.
  - Perform the WIN VERIFICATION TEST. See DTC-Based Diagnostics/NODE, Wireless Ignition (WIN) - Standard Procedure
  No
  - The repair is complete.
  - Perform the WIN VERIFICATION TEST. See DTC-Based Diagnostics/NODE, Wireless Ignition (WIN) - Standard Procedure
INTERMITTENT CONDITION
1. Turn the ignition off.
  NOTE:
  Check for the following conditions:
  - Visually inspect the related wiring harness. Look for any chafed, pierced, pinched, or partially broken wires.
  - Visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals.
  - Refer to any Technical Service Bulletins (TSB) that may apply.
  Were any problems found?
  
  Yes
  - Repair wiring harness/connectors as necessary.
  - Perform the WIN VERIFICATION TEST. See DTC-Based Diagnostics/NODE, Wireless Ignition (WIN) - Standard Procedure
  No
  - Test Complete.