Diagnostic Test

PROGRAM ALL OF THE IGNITION KEYS
1. Turn the ignition on.
2. With the scan tool, attempt to program the key(s) into the WIN.
  Was the programming of the key(s) successful?
  
  Yes
  - Perform the WIN VERIFICATION TEST. See DTC-Based Diagnostics/NODE, Wireless Ignition (WIN) - Standard Procedure .
  No
  - Replace the ignition key and attempt to program it into the WIN. If the DTC resets, replace and program the Wireless Ignition Node (WIN) in accordance with the Service Information.
    NOTE: If this vehicle is equipped with a Steering Column Lock Module, it must be replaced along with the WIN.
  - Perform the WIN VERIFICATION TEST. See DTC-Based Diagnostics/NODE, Wireless Ignition (WIN) - Standard Procedure .