STABILIZER BAR, Front: Removal: Rear-Wheel-Drive

Fig 1: FRONT STABILIZER BAR HEAT SHIELD

Courtesy of CHRYSLER LLC

1. Raise and support vehicle. Refer to Vehicle Quick Reference/Hoisting - Standard Procedure .
2. Remove belly pan. Refer to Body/Exterior/BELLY PAN - Removal .
3. On each side of vehicle, remove screws (1) fastening stabilizer bar heat shield (3). Remove heat shield.
   Fig 2: FRONT STABILIZER BAR ISOLATOR RETAINER BOLTS

   Courtesy of CHRYSLER LLC
4. On each side of vehicle, remove bolts (2) fastening stabilizer bar isolator retainer (1) in place.
   Fig 3: FRONT STABILIZER BAR ISOLATOR RETAINER

   Courtesy of CHRYSLER LLC
5. On each side of vehicle, remove retainer halves (1) (2) from around stabilizer bar isolator (3).
   Fig 4: FRONT STABILIZER BAR ISOLATOR ON BAR

   Courtesy of CHRYSLER LLC
6. Utilizing slit, remove each isolator (1) from stabilizer bar (2).
   Fig 5: LINK BALL JOINT AT STABILIZER BAR

   Courtesy of CHRYSLER LLC
7. On each side of vehicle, remove nut (5) fastening stabilizer link (3) to stabilizer bar (4). Slide link ball joint stem (1) from bar, then remove bar from vehicle.