HOSE, Power Steering, Supply: Installation: Installation

Fig 1: REMOTE RESERVOIR

Courtesy of CHRYSLER LLC

1. Install reservoir end of supply hose (3) on reservoir hose fitting. Install clamp securing hose in place.
   Fig 2: SUPPLY HOSE - 2.7L/3.5L

   Courtesy of CHRYSLER LLC
2. 2.7L/3.5L Engines - Install supply hose (3) on pump. Install clamp (2) securing hose in place.
   Fig 3: SUPPLY HOSE - 5.7L/6.1L

   Courtesy of CHRYSLER LLC
3. 5.7L/6.1L Engines - Install supply hose (3) on pump (1). Install clamp securing hose in place.
   Fig 4: SUPPLY HOSE - 3.0L DIESEL

   Courtesy of CHRYSLER LLC
4. 3.0L Diesel Engine - Install supply hose (3) on pump (1). Install clamp (2) securing hose in place.
5. Install air cleaner housing and inlet tube. Refer to Engine/Air Intake System/BODY, Air Cleaner - Installation
   Fig 5: BATTERY AND CABLES

   Courtesy of CHRYSLER LLC
6. Connect battery negative cable (2) to battery post. It is important that this is performed properly. Refer to Electrical - Engine Systems/Battery System - Standard Procedure
7. Fill and bleed power steering system. See Steering - Standard Procedure