HOSE, Power Steering, Pressure: Removal: Right-Hand-Drive

Fig 1: BATTERY AND CABLES

Courtesy of CHRYSLER LLC

1. Disconnect and isolate battery negative cable (2) from battery post.
2. Siphon power steering fluid from pump reservoir.
3. Remove air cleaner housing and inlet tube to throttle body. Refer to Engine/Air Intake System/BODY, Air Cleaner - Removal
   Fig 2: PRESSURE HOSE AT PUMP - 2.7L/3.5L

   Courtesy of CHRYSLER LLC
4. 2.7L/3.5L Engines - Unthread tube nut, then remove pressure hose (2) from pump (1).
   Fig 3: PRESSURE HOSE AT PUMP - 5.7L/6.1L

   Courtesy of CHRYSLER LLC
5. 5.7L/6.1L Engines - Unthread tube nut, then remove pressure hose (2) from pump (1).
   Fig 4: PRESSURE HOSE AT PUMP - 3.0L DIESEL

   Courtesy of CHRYSLER LLC
6. 3.0L Diesel Engine - Unthread tube nut, then remove pressure hose (2) from pump (1).
7. Raise and support vehicle. Refer to Vehicle Quick Reference/Hoisting - Standard Procedure
8. Remove belly pan. Refer to Body/Exterior/BELLY PAN - Removal
   Fig 5: POWER STEERING HOSE ROUTING - RHD

   Courtesy of CHRYSLER LLC
9. Remove screws (2) securing pressure hose (1) routing clamp to engine cradle.
10. Remove screw (7) securing pressure hose (1) routing clamp to engine cradle.
11. Unthread pressure hose tube nut (5) from steering gear.
12. Remove pressure hose (1) from vehicle.