HOSE, Power Steering, Pressure: Removal: All-Wheel-Drive

Fig 1: BATTERY AND CABLES

Courtesy of CHRYSLER LLC

1. Disconnect and isolate battery negative cable (2) from battery post.
2. Siphon power steering fluid from pump reservoir.
3. Remove air cleaner housing and inlet tube to throttle body. Refer to Engine/Air Intake System/BODY, Air Cleaner - Removal
   Fig 2: PRESSURE HOSE AT PUMP - 3.5L

   Courtesy of CHRYSLER LLC
4. 3.5L Engine - Unthread tube nut, then remove pressure hose (2) from pump (1).
   Fig 3: PRESSURE HOSE AT PUMP - 5.7L/6.1L

   Courtesy of CHRYSLER LLC
5. 5.7L/6.1L Engine - Unthread tube nut, then remove pressure hose (2) from pump (1).
6. Raise and support vehicle. Refer to Vehicle Quick Reference/Hoisting - Standard Procedure
7. Remove belly pan. Refer to Body/Exterior/BELLY PAN - Removal
   Fig 4: HOSE MOUNTING BRACKET TO CRADLE

   Courtesy of CHRYSLER LLC
8. Remove screw fastening pressure hose routing clamp (1) to front of engine cradle (2).
9. Remove screw fastening pressure hose routing clamp to left side of engine cradle.
   Fig 5: HOSES AT AWD GEAR

   Courtesy of CHRYSLER LLC
10. Unthread return hose tube nut (1), then remove return hose from steering gear (2).
11. Unthread pressure hose tube nut (3), then remove pressure hose from steering gear (2) and vehicle.