- Install pressure hose in engine compartment from underneath.
Courtesy of CHRYSLER LLC
NOTE:
Always use a NEW O-ring on the end of the pressure hose.
- Lubricate NEW O-ring on steering gear end of pressure hose with clean power steering fluid.
- Install pressure hose (2) to steering gear (1). Do not tighten tube nut at this time.
Courtesy of CHRYSLER LLC
- Route pressure hose along right side of engine cradle. Position pressure hose (1) routing clamp over return hose (2) routing clamp, then install screw (4) securing hoses to right side of engine cradle (3).
- Route pressure hose along front of engine cradle. Install screw (5) through routing clamp securing hose to front of engine cradle (3).
Courtesy of CHRYSLER LLC
- Tighten pressure hose tube nut at steering gear to 47 N.m (35 ft. lbs.).
- Install belly pan. Refer to Body/Exterior/BELLY PAN - Installation
- Lower vehicle.
NOTE:
Always use a NEW O-ring on the end of the pressure hose.
- Lubricate NEW O-ring on power steering pump end of pressure hose with clean power steering fluid.
Courtesy of CHRYSLER LLC
- 2.7L/3.5L Engines - Install pressure hose (2) to pump (1). Tighten pressure hose tube nut to 47 N.m (35 ft. lbs.).
Courtesy of CHRYSLER LLC
- 5.7L/6.1L Engines - Install pressure hose (2) to pump (1). Tighten pressure hose tube nut to 47 N.m (35 ft. lbs.).
Courtesy of CHRYSLER LLC
- 3.0L Diesel Engine - Install pressure hose (2) to pump (1). Tighten pressure hose tube nut to 47 N.m (35 ft. lbs.).
- Install air cleaner housing and inlet tube. Refer to Engine/Air Intake System/BODY, Air Cleaner - Installation
Courtesy of CHRYSLER LLC
- Connect battery negative cable (2) to battery post. It is important that this is performed properly. Refer to Electrical - Engine Systems/Battery System - Standard Procedure
- Fill and bleed power steering system. See Steering - Standard Procedure