Inner Tie Rod

Remove outer tie rod. See Steering/Gear/TIE ROD, Steering - Removal
Remove tie rod jam nut from inner tie rod.

Fig 1: INNER TIE ROD BELLOWS HEAT SHIELD
Courtesy of CHRYSLER LLC

NOTE: If equipped with All-Wheel-Drive, it may be necessary to remove heat shield (3) above inner tie rod bellows (2) to allow better access to bellows clamp.

Fig 2: BELLOWS CLAMPS
Courtesy of CHRYSLER LLC
Remove clamp (1) securing bellows (3) to inner tie rod.
Remove clamp (2) securing bellows (3) to steering gear body.
Remove bellows (3).

Fig 3: INNER TIE ROD HEX
Courtesy of CHRYSLER LLC
Install appropriate inner tie rod removal tool on inner tie rod hex (1).
CAUTION: If inner tie rod cannot be removed using specified tools, do not use a hammer or heat to loosen. Damage to steering gear will occur. Replace entire steering gear.
Unthread and remove inner tie rod (2).

Fig 4: RESTRICTOR REMOVAL/INSTALLATION
Courtesy of CHRYSLER LLC
Remove travel restrictor (2) from rack gear (3).