Outer Tie Rod - All-Wheel-Drive

Fig 1: AWD TIE RODS

Courtesy of CHRYSLER LLC

CAUTION: When rotating inner tie rod, use care not to twist bellows at inner tie rod. Remove clamp (2) at inner tie rod and make sure bellows moves freely before rotating inner tie rod.

Thread outer tie rod (4) onto inner tie rod (3), Install outer tie rod same number of turns as when removed.

Fig 2: TIE ROD ATTACHMENT AT KNUCKLE
Courtesy of CHRYSLER LLC
Install outer tie rod end (2) into steering knuckle (3). Install and tighten nut (1) to 85 N.m (63 ft. lbs.).

Fig 3: TIRE AND WHEEL MOUNTING
Courtesy of CHRYSLER LLC
Install tire and wheel assemblies (1). Tighten wheel mounting nuts (3) to 150 N.m (110 ft. lbs.) (Police - 190 N.m (140 ft. lbs.)). Refer to Tires and Wheels - Installation
Lower vehicle.
Perform wheel alignment setting toe to specifications. Refer to Front Suspension/Wheel Alignment - Standard Procedure

Fig 4: AWD TIE RODS
Courtesy of CHRYSLER LLC
Tighten tie rod jam nut (1) to 75 N.m (55 ft. lbs.).