Diagnostic Test

REPLACE OCCUPANT RESTRAINT CONTROLLER (ORC)
1. Turn the ignition on.
2. With the scan tool, erase and read ORC DTCs.
  WARNING: Turn the ignition off disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
  
  WARNING: If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to take the proper precautions could result in accidental airbag deployment. Failure to follow these instructions may result in possible serious or fatal injury.
  
  When this code is set, view repair.
  
  Repair
  - Replace the Occupant Restraint Controller (ORC) in accordance with the Service Information.
  - Perform the RESTRAINTS SYSTEM VERIFICATION TEST. See DTC-Based Diagnostics/CONTROLLER, Occupant Restraint (ORC) - Standard Procedure .