Diagnostic Test

DETERMINING IF DTC IS CURRENT
NOTE: Diagnose any related Communication DTC(s) before continuing.
1. With a scan tool, read and record DTC(s).
2. With the scan tool, clear DTC(s).
3. Turn the ignition off and remove the key from the ignition.
4. Lock and close all doors to allow the VTSS to go from pre-arm to armed status and wait one minute.
5. Disarm the VTSS.
6. Using the scan tool, read DTC(s).
  Does the DTC reset?
  
  Yes
  - Remove the Cluster and inspect the Fused B (+) and both CAN B BUS circuits for spread terminals or intermittent opens.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .
  No
  - DTC is not active at this time. Test complete.