LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (6.1L Engine (Service Information)) >> Engine Block >> BEARING(S), Crankshaft, Main >> Standard Procedure >> Crankshaft Main Bearing - Fitting >> Main Bearing Journal Diameter (Crankshaft Removed)

Main Bearing Journal Diameter (Crankshaft Removed)

WARNING: This page is about a different variant/trim than selected.

Crankshaft removed from the cylinder block.

Clean the oil off the main bearing journal.

Determine the maximum diameter of the journal with a micrometer. Measure at two locations 90° apart at each end of the journal.

The maximum allowable taper is 0.008 mm (0.0004 inch.) and maximum out-of-round is 0.005 mm (0.0002 inch). Compare the measured diameter with the journal diameter specification (Main Bearing Fitting Chart). Select inserts required to obtain the specified bearing-to-journal clearance.

scientia non olet · About LEMON Manuals